Problem get spark output

A forum for discussing topics of particular interest to those running MegaSquirt in Australia and New Zealand, including parts sources, group buys, etc.
Post Reply
spacko oz
MegaSquirt Newbie
Posts: 2
Joined: Mon Oct 20, 2008 2:38 am

Problem get spark output

Post by spacko oz »

Hi i have a MSII V3.0 and going to use it on a EF falcon 5.0 with TFI. I have built the system and installed it in the car, i receive a signal from the dizzy but can not get a signal out ( I am using a MSD 6A ) to the white wire. I have been over and over the system checking jumpers and what nots but cannot work out what is going on.
Is there anyone in australia who is willing to look at it and figure out what is going on.
Any help be grateful
matt
devojet
Helpful Squirter
Posts: 82
Joined: Tue Jun 05, 2007 7:40 pm
Location: Gold Coast

Re: Problem get spark output

Post by devojet »

Hi Matt,

Where are you located?

Can you list out how you have jumpered the spark output? Can you post your MSQ file?

Cheers

Daniel.
26 Chev hotrod with a 1UZFE and MS3x, Flex fuel, GPIO Transmission control and LCDash.
LS3 powered Race boat with MS3pro and GPIO.
MS2 on a 22r in a Hilux (mates car).
MS2extra on a turbo EF Falcon (brothers car).
Toyota Supra 1jz MS2extra, COP.
13B Turbo MS2extra.
spacko oz
MegaSquirt Newbie
Posts: 2
Joined: Mon Oct 20, 2008 2:38 am

Re: Problem get spark output

Post by spacko oz »

Hi, i have set the output options up per diyauto tune web page for tfi and the msII as instructions on the same page.
I have included a msq file but it isn't set up yet, just enough to see wats going on, the car isn't ready for starting yet.
I live in south aus about 1hr from adelaide.
Any suggestions would be greatful
cheers matt
Attachments
megasquirt200810191122.msq
(25.14 KiB) Downloaded 1021 times
Post Reply