confused assy, help needed

A forum for discussing topics of particular interest to those running MegaSquirt in Australia and New Zealand, including parts sources, group buys, etc.
Post Reply
rod baker
MegaSquirt Newbie
Posts: 6
Joined: Thu Feb 21, 2008 3:00 pm
Location: mallabula near newcastle nsw

confused assy, help needed

Post by rod baker »

hi all i am having problems working out which bits to do .
i have V3 board running ms 2 daughter board and i am upto operation 20 and i will be doing it as a PWM ford idle controll i have done the operation 62 which is fitting a different transistor in Q4 .
it goes on to talking about CAN comunications and jumper wires do i need these for my set up i am not sure which way to go



rod baker
Rod baker 1982 Landcruiser with ford XR8 5 litre building a Megasquirt 2 pcb3.0
devojet
Helpful Squirter
Posts: 82
Joined: Tue Jun 05, 2007 7:40 pm
Location: Gold Coast

Re: confused assy, help needed

Post by devojet »

You won't need the CAN jumpers unless you will be running a GPIO board. The rest of the jumpers will depend on your ignition system.

Cheers

Daniel.
26 Chev hotrod with a 1UZFE and MS3x, Flex fuel, GPIO Transmission control and LCDash.
LS3 powered Race boat with MS3pro and GPIO.
MS2 on a 22r in a Hilux (mates car).
MS2extra on a turbo EF Falcon (brothers car).
Toyota Supra 1jz MS2extra, COP.
13B Turbo MS2extra.
Post Reply