www.MSgroups.com read only forum (Jan.15,2018)

Hi i have a MSII V3.0 and going to use it on a EF falcon 5.0 with TFI. I have built the system and installed it in the car, i receive a signal from the dizzy but can not get a signal out ( I am using a MSD 6A ) to the white wire. I have been over and over the system checking jumpers and what nots but cannot work out what is going on.
Is there anyone in australia who is willing to look at it and figure out what is going on.
Any help be grateful
matt

Hi Matt,

Where are you located?

Can you list out how you have jumpered the spark output? Can you post your MSQ file?

Cheers

Daniel.

Hi, i have set the output options up per diyauto tune web page for tfi and the msII as instructions on the same page.
I have included a msq file but it isn't set up yet, just enough to see wats going on, the car isn't ready for starting yet.
I live in south aus about 1hr from adelaide.
Any suggestions would be greatful
cheers matt