www.MSgroups.com read only forum (Jan.15,2018)

hi all i am having problems working out which bits to do .
i have V3 board running ms 2 daughter board and i am upto operation 20 and i will be doing it as a PWM ford idle controll i have done the operation 62 which is fitting a different transistor in Q4 .
it goes on to talking about CAN comunications and jumper wires do i need these for my set up i am not sure which way to go



rod baker

You won't need the CAN jumpers unless you will be running a GPIO board. The rest of the jumpers will depend on your ignition system.

Cheers

Daniel.